For example, locate the reject bin，First make sure the air pressure is enough，the position of the inducti...

There are two types for different use locations.

1、Upper and lower overrun switch.2、Upper maintenance switch of the hot storage bin.3、Emergency stop switch of the hot storage bin control cabinet 4、Trolley stop switch of operation console .

1、an electronic over temperature switch at the inlet of the filter.2、Computer parameters.

When working, the outlet temperature should not be lower than 80.

Feed port, feed end seal ring, Rap ring, discharge end seal ring.

Correct relationship between frequency and oil pressure of frequency converter, If there is alarm signal on the touch screen, check the alarm reason .

Two. The fuel injection valve will be blocked by foreign matters, resulting in loose closing and oil leakage during preheating .

After stopping the production, turn the blowing knob to the blowing position, and turn it back to the production position before preheating the next production.

Maximum, minimum pressure；Air oil ratio control screw.

Check whether the oil pipe and air pipe are connected correctly； wiring，the position of the lance，the pos...

After calibration, the users can get the parameters.The menu path:[System Setup]→[Scale Setup]→[Get param...

1.Check the scale configuration.2.Check the load cell.The replacement can be used to check if the load ce...

The Free Calibration provides access to the span calculation screen for precalibration of a scale witho...

Powerup ZeroIf Poweruo Zero is enabled, the terminal tries to capture zero upon power uo. If Powerup Zero capture is enabled and the weight on the scale is outside of the zero capture range , the display will indicate “EEE” or “-EEE” until the weight is removed and zero is capture.Range:0%(Powerup ...

D-TIME Start up delay time, generally set to 5-15 seconds。 O-TIME dela...

Press the switch of CPU to “MRES” position，When the stop light flashes...

The shielding layer of signal line shall be single ended grounded , and ...

less than or equal to 4 ohm.

When the three-phase 380V power supply is used, the resistance wire adop...

1、Screw tightening of linkage parts；2、Oil level and quality of reducer ；...

1、Bag and support of Filter；2、Oil quantity an...

1、Track inspection of movement direction of discharge port and feeding b...

The way of maintenance of pneumatic parts 1. Periodically clean the air f...

1. After new machine having worked 100 hours since initial production, a...